UNI-T UT60D Spezifikationen PDF herunterladen (Seite 22)

Note

l The test leads can add 0.1 to 0.2 of error to

resistance measurement. To obtain precision

readings in low-resistance measurement, that is the

range of 340.0 , short-circuit the input terminals

beforehand and record the reading obtained (called

this reading as X). (X) is the additional resistance

from the test lead.

Then use the equation:

measured resistance value (Y) - (X) = precision

readings of resistance.

l For high-resistance measurement (>1M ), it is

normal taking several seconds to obtain a stable

reading.

l If reading with shorted test leads is not

0.5 ,

check for loose test leads, incorrect function selection,

or enabled Data Hold function.

l The LCD displays

indicating open-circuit for the

tested resistor or the resistor value is higher than

the maximum range of the Meter.

l When resistance measurement has been completed,

disconnect the connection between the testing leads

and the circuit under test.

C. Frequency & Revolution (RPM) Measurement

(see figure 8)

Measurement Operation (6)

(figure 8)

blackred

Model UT60D: OPERATING MANUAL

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 41 42

Keine Kommentare

UNI-T UT60D Spezifikationen Seite 22